Problem 1

Every time we change the coolant it goes off again within a few months

--›Solution

You need to change to a more robust, Gulf long life Coolant. But before dumping your old coolant, and filling up with new, it’s vital that you get rid of the bacteria in your machine system first. This is simple and straightforward. All you have to do is add a 2% dose of Gulf System Cleaner to your old coolant, and continue in use for 24 to 48 hours before you dump it. This will clean and sterilize your machine, and greatly extend the life of your new coolant.   This is a vital part of the process.  After that, Gulf Long Sump Life Coolant, topped up regularly, will give you months or even years of superb system performance!

Problem 2

Our high pressure machines are also high foaming

--›Solution

This is a very common problem. The first thing to check is that the coolant concentration isn’t running too high. If this is not the case you need to change to a coolant which is designed for use in soft water areas. Gulf have several high quality very low foam coolants, and the one which is most suitable will depends on how soft your local water is, and the speed and filtration system of your machines. In extreme cases it may also be necessary for you to use Gulf Anti-Foam Additive, but we can give you advice on this.

Problem 3

Our operators keep getting skin irritations

--›Solution

It is always best to protect the skin and lungs from exposure to any cutting fluids. However, Gulfcut Soluble Coolants contain less harmful constituents than many competitors products. Our range also includes grades that are based on unique chemistry which require no Hazard Labelling. All of these products offer enhanced operator safety, without compromising on machining performance.

Problem 4

We suffer from significant leaks of slideway lubricants or hydraulic oil into the coolant

--›Solution

Gulf Aqua-Guard slideway and hydraulic oils incorporate revolutionary unique additive systems that keep tramp oils separate from the coolant by preventing emulsification.  This prolongs the life of the coolant and enhances Health & Safety.

Problem 5

We keep getting an oily scum that floats on top of our coolant

--›Solution

This is a problem in hard water areas, which is resolved by the use of Gulfcut HW PLUS, a semi-synthetic coolant specially designed for use in very hard water areas.

Problem 6

We get sticky deposits on machine surfaces

--›Solution

This is caused by coolants that are based on old technology constituents, and is also one of the main causes of coolant loss by swarf “drag-out” Change to any of the Gulfcut product range.

Problem 7

We get rust and staining problems on machined parts and machine surfaces.

--›Solution

This can be caused by low fluid concentration or lack of corrosion protection in the coolant. Gulf will advise on a suitable product that will give high levels of corrosion protection and enhanced surface finish.